Binzhou - Type 054A FFG

1
September 26, 2021
Many of the bigger parts are slide molded and do not require much assembly... thus this is the result after about 10minutes of unpacking, cutting and dryfitting it all together
2
September 26, 2021
Finished the basic parts of the superstructure. As the parts were slidemolded, there were no real issues with alignment. Note that Iused black glue
3
September 26, 2021
Stabilizers, screws and shafts were glued in place on the lower hull
4
September 26, 2021
It´s photoetch time! The Tetra stuff seems rather nice, although it´s super fiddly
5
October 2, 2021
ANother bit of work was finally done today! I glued on some more PE and glued the main superstructure on. I still have to do some filling
6
October 2, 2021
The PE-details look quite nice on the missile launchers
7
October 7, 2021
Got smoe more progress! Got the sides (more or less) properly sanded.
8
October 7, 2021
So more PE has also been fitted. The ship really starts to look quite delicate
9
October 7, 2021
Funnel and rear mast
10
October 7, 2021
Front mast and bridge area. It´s just missing the bigg radar on top...
11
October 9, 2021
Assembly is finsihed. Mayor and minor subassemblies are left removable for easier painting
12
October 9, 2021
The bow area is full of rockets, radomes and stuff
13
October 9, 2021
PE doors and ladders bring some nice additional detail around the mid section
14
October 9, 2021
The main radar has its two main parts tilted slightly aginst each other, making it look rather interesting
15
October 9, 2021
And I´ve built a micro-chopper to sit on the helo-deck
16
October 23, 2021
Basic painting and washing is done... I still have to paint the stand in black
17
October 23, 2021
18
October 23, 2021
19
October 24, 2021
Approaching the finish-line of this one
20
October 24, 2021
Micro-decaling... got to touch up the window-parts though
21
October 30, 2021
Final photos of the finished model!
22
October 30, 2021
23
October 30, 2021
24
October 30, 2021
25
October 30, 2021
26
October 30, 2021
27
October 30, 2021
28
October 30, 2021
29
October 30, 2021
30
October 30, 2021
31
October 30, 2021
32
October 30, 2021
33
October 30, 2021
I found out, that I still had the flyer from visting the ship... it made for a nice display option 🙂
34
October 30, 2021
35
October 30, 2021

Коментари

16 December 2024, 11:11 -

Album info

Using Trumpeters 1/700 kit and Tetra Model Works photoetch elements, I am building the Chinese PLAN frigate Binzhou (515) as I had seen her in person at an Open Ship event at the Kieler Woche in Northern Germany in 2018.

Binzhou - PLAN Type 054A Frigate

35 снимки

1:700

Завършен

1:700 PLA Navy Type 054A Frigate Detail-up Set (Tetra Model Works SE-70029)

Всички албуми

Преглед на всички албуми »