Brun Porsche 962C Norisring 1987

Done 

The headlight covers are B A D. But it's done. 

Aah! Now it was my turn to screw up! I put these little elk head decals on the inside of the rear wing, missing the fact they belong on the front, below and to the side of each headlight. Dog gone it ; ) 

All covered up, nicely 

Filled in and smoothed down, but now I get to touch up that little bit of paint.....always has to turn into a THING. 

....and good enough to cover with a decal. 

Oooh! Those Hasegawa bas..... got me again! That's okay, not beaten yet. Stuff some epoxyputty in the offending hole, smooth it off, cover it with a decal. That offending vent should be forward over the cabin. 

Getting back to this, some 2 years later ( already?! ). I wound up hating the TS 12 orange and went to the airbrush ( yuck!) using Tamiya LP51 orange over an undercoat of LP8 pure yellow. 

Cut off the protruding ducts and cap off with some sheet styrene. 

 

"Partially different". That's an understatement. Rear brakes: wrong. Ducts on the top: wrong. Side vents infront of the exhaust: there ain't none! I'm certain the rear wing mounts are incorrect. No openings at front of sides. And I don't think the actual car had the diffuser under the butt end. Still better than Tamiyas slot car kit, I suppose. 

Really pleased with the chrome on the wheels. When I airbrushed the Spazstick chrome on, it didnt look very good but set nicely. 

 

90% correct....?