Type IX C/40 U-190

Up next; Revells new tool type IX C40 

The real U-190 after it's surrender. 

 

 

The real U-190 after it's surrender
Looks like it has some camouflage painting on the sides, the part where the star is painted loom lighter than the part of the snorkel arrangement. 

First step is drilling holes, and many of them 🙂 

Hull glued, fit is near perfect  

There are some annoying pin marks that cause fit issues and needs additional work.
The ones here cause a small gap in the drive shaft housing. There are also pin marks on the snorkel and the forward torpedo tubes that need work in order to get it smooth.  

Torpedo doors in the open position. Also note the over scale weld seams. 

GHG receiver balcony needed quite some work as it is a multi part moulding.
I used plastic strip to sort the gap between the balcony and the keel. 

Added the anti radar material and the 'Bali 1' antenna to the snorkel. 

 

 

 

With some paint on it looks ok 

Tower in progress  

Fit is quite good  

Deck glued in place, snorkel is clamped in and moveable  

More work on the tower. 

Drilled out the snorkel  

 

 

 

Why are there knockout pin marks on the periscopes Revell? 2024 tooling should be better than this? 

And how does this.... 

.... resemble this?? 

Started reworking the kit part, it won't be perfect, but at least less crude. 

Started reworking the kit part, it won't be perfect, but at least less crude. 

Dipoles added with stretched sprue  

An attempt to scratch a new gun shield for the doppelflak 

3,7cm doppelflak