Polaris MRZR build thread

Packaging from the shop 

Inside look on the 6 zip-lock packets 

6 Packets inside the box 

unboxing 

most fragile packet with foam wrapped on these 3 parts
Packet A
front bumper rail
rear bumper rail
rear tow hitch 

Packet B
Rollover side bars
Side handle railing
Rollover cross bar
Rear tray railings 

Packet C
Steering columns
Hitch and handles (broken)
Suspension front
Torsion axial front
Torsion axial rear 

Packet D
4 x tire/wheels
Side steps
Tail gate
Rollover front bar 

Packet E
Chassis Front
2 x seats 

Packet F
Chassis Rear
Exhaust
Chassis bottom frame 

Broken part on the tail gate frame brackets 

Frame dimension is smaller than the chassis 

poor alignment between the guidepins 🙁 

Wash and dry from resin kit parts 

Different exhaust design between C2 n MRZR, length longer on the C2 

Comparing the size between the C2 and MRZR 

Filing and prep for front and rear chassis 

Dry fitting after filing 

Axial is turned, to the right

Updated: turned to the same direction  

Parts for axials, suspension, chassis frames and exhaust 

Front axial with suspension  

Rear axial  

Angled to the forward on the front axial. The wheels are aligned straight at this angle.
This is correct? 

Chassis frame front 

Chassis frame rear in 2 pieces 

Easier to fix these axials first before joining the front and rear chassis 

Dry fitting on the axial chassis steps 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Dry fit on rear bumper and tow hitch 

 

 

 

 

 

 

 

 

 

Assembly on rear axial 

Assembly on front axial 

Assembly on front axial, left side is too high 

Extending tow hitch hole using 0.8mm drill bit 

Tow hitch is still too tight after drilling with 1mm drill bit 

Extending tow hitch hole using 1.5mm drill bit 

Dry fit tow hitch after extending to diameter 1.5mm (bottom view) 

Dry fit tow hitch after extending to diameter 1.5mm 

Dry fit tow hitch after extending to diameter 1.5mm 

Shortening rear bumper rod for tighter fit with chassis 

Rear bumper and tow hitch assembly (bottom view) 

Rear bumper and tow hitch assembly (right view) 

Rear bumper and tow hitch assembly (rear view) 

Fitted the side steps (top view) 

Fitted the side steps (bottom view). A little scrappy on the fittings :-/ 

 

 

 

 

 

 

 

 

 

 

 

 

Most frustrating the lug broke again while installing the tailgate. Now back to reworking the lugs again!!?? 

Finally managed to break all the tailgate lugs 🙁 🙁 🙁 

 

 

Broke again! Good thing all the lugs break clean :-/ now I’m quite good at fixing this micro parts 

 

 

 

3 completed without their rollbar