Subaru Impreza Rally Japan 2004
Komentáře
17 25 November 2022, 22:50
bossy122
Thanks, because these things are a ROYAL pain. It's taking almost boiling water just to get them off the paper. Both Subaru emblems cracked along the rear fender. I have this Vallejo paint that is almost a perfect match to the neon green but, for whatever reason, it dried more yellow. This car may wind up getting some weathering.
Thanks, because these things are a ROYAL pain. It's taking almost boiling water just to get them off the paper. Both Subaru emblems cracked along the rear fender. I have this Vallejo paint that is almost a perfect match to the neon green but, for whatever reason, it dried more yellow. This car may wind up getting some weathering.
27 November 2022, 07:06
Kyle DeHart
Fought my share of old and stubborn decals and it's never fun. I have no doubt this will look good. Weathering a rally car…might as well. They're rarely clean anyway. Look forward to seeing it.
Fought my share of old and stubborn decals and it's never fun. I have no doubt this will look good. Weathering a rally car…might as well. They're rarely clean anyway. Look forward to seeing it.
27 November 2022, 08:39
bossy122
Not for the 04 and 05s, sadly. That's okay, I can soldier on with these, I'm almost done. ( To be clear: there are after markets made, there aren't any available.)
Not for the 04 and 05s, sadly. That's okay, I can soldier on with these, I'm almost done. ( To be clear: there are after markets made, there aren't any available.)
27 November 2022, 20:04
Kyle DeHart
It's looking good. Your patience is paying off. I love these cars and liveries.
It's looking good. Your patience is paying off. I love these cars and liveries.
28 November 2022, 00:39
bossy122
I actually found some aftermarket decals. But somehow, it didnt occur to the printer to cut out the door handle parts......think i'll stick with what I have. Now to the chassis and interior.....which means harnesses......yuck.
I actually found some aftermarket decals. But somehow, it didnt occur to the printer to cut out the door handle parts......think i'll stick with what I have. Now to the chassis and interior.....which means harnesses......yuck.
1 December 2022, 05:42