Mirage Hobby Transporter Renault UE

1
February 7, 2023
A new manufacturer to me, but the moulding looks nice and crisp, except for a little flash here & there.
2
February 9, 2023
The running gear is a bit more complicated than some and has some EP marks and one or two sink marks. The hull needs a bit of Mr Surfacer around the outside edges.
3
February 9, 2023
The more I look, the more EP marks and sink marks I find. I might buy shares in Mr Surfacer at this rate.
4
February 10, 2023
Well, I've actually managed to assemble some of it at last. I think this is going to be one of those build, paint, build, paint, repeat until finished kits.
5
February 11, 2023
Progress is slower than I was anticipating as I had to detach the trailer hitch from the bottom of the trailer. The hitch consists of 10 (!) separate parts, none of which fit together well. I'm finding that a constant issue with this kit.
6
February 15, 2023
The vehicle moved around on a pair of inline skates by the look of it. Fiddly to both assemble and paint.
7
February 16, 2023
Test fitting the wheels & fuel tank on the trailer.
8
February 16, 2023
Lots of Mr Surfacer required, which I've still got to cut back.
9
February 17, 2023
It's gradually coming together. Tomorrow, I'll get some primer on it, then a base coat.
10
February 17, 2023
The tracks are link & length on the carrier and rubber band on the trailer. There looks to be enough rubber band track to do the carrier as well if you prefer. I wouldn't want to try metal tracks on this!
11
February 18, 2023
The base coat is done & the running gear fitted (except the drive sprocket)
12
February 18, 2023
The fuel tank in the trailer is a very vague fit. How far down in to the trailer should it be pushed? It doesn't sit flat if you push it all the way down.
13
February 20, 2023
Semi-gloss coat done. Now for the washes, filters, etc.
14
February 20, 2023
The exhaust is rusted and fitted. I think the tracks will be next.
15
February 21, 2023
First side of tracks are in place. I can't say I'm that happy with the result having never attempted this type of tracks before. Hopefully the other side will be a bit better. I had to add an extra single link at both drive and idler end. There are 10 spares in the kit, so that's not a problem. At least I managed to get a bit of sag into the top run without breaking the parts! Edit: Gas Hans have just released a set of tracks for this.
16
February 21, 2023
And the other side is done. That went a bit better.
17
February 21, 2023
The tracks have had a dose of track wash and the treads rubbed with dark steel pigment.
18
February 21, 2023
That shovel is supposed to be mounted further to the left, but there is not enough room between the hull side & the track for it to fit. Looking at several photos, it doesn't seem to have been mounted very often anyway. This kit is leading a bit of a charmed life. Yesterday I knocked over the glue bottle...and twice again today, and the black paint too. Missed it every time.
19
February 23, 2023
The decals are on and the chipping is (mostly) done. It's barely visible under this lighting.
20
February 23, 2023
A comparison of the original and FC Model Trends MG's
21
February 24, 2023
Streaking & dirt added. I might tone down some of the dirt a bit, but looking at old photos, these crates did get filthy, probably due to the open tracks.
22
February 24, 2023
Still to do: Trailer wheel units (when the tracks arrive), varnish effect on MG butt, mount MG, oil/fuel stains,smoke on end of exhaust/front of storage bin, fit fuel pump to tank & matt varnish coat. I'm experimenting with making a tarpaulin to cover the tank, as shown on the box art. This also shows a hose wrapped around the tank.
23
March 8, 2023
Finally, they've arrived! I'll get back on this soon. The tracks look good. Let's hope the fit is okay.
24
March 8, 2023
The fit is not okay. I wonder if I could remove a few links? Nothing to lose by trying, I suppose.
25
March 10, 2023
I decided to save the new tracks for another project. In the meantime, back to the original rubber band tracks. I cut them to a little longer than needed, then test fitted and removed one link at a time until I was happy with the fit. The rest was CA all the way. The biggest issue is that the tracks are far wider than the wheels. I think the track horns are a bit small too. It's not too bad though. A bit of wash & dirt will hide any flaws.
26
March 10, 2023
The trailer tracks are in place. I'm going to have a go at the tarpaulin tomorrow. Let's see if my skill with a needle is up to the job!
27
March 13, 2023
Phew! This is a new tarp, as I managed to get the cotton too tight on the first one and ripped it. Just having a break to let the pipe set in place, catch my breath and mop the sweat from my brow after that. Once the cement had set, I can very carefully tighten the cotton a little and secure the loose ends. A dab of CA should secure each of the four knots. Then I can add some staining to it.
28
March 13, 2023
All that remains now is a matt coat and some daylight photos.
29
March 13, 2023
It's come out okay for a cheap kit, with a new MG and scratch tarpaulin.
30
March 13, 2023
31
March 13, 2023
32
March 13, 2023
33
March 13, 2023
34
March 13, 2023
35
March 13, 2023
36
March 14, 2023
Completed. I actually got some sunshine for the photos too.
37
March 14, 2023
38
March 14, 2023
39
March 14, 2023
40
March 14, 2023
41
March 14, 2023
42
March 14, 2023
43
March 14, 2023

Comentarios

19 7 February 2023, 19:14

Villiers de Vos
Very nice progress.

10 February 2023, 03:55

Robert Podkoński
Keep calm and carry on, John! 😉

15 February 2023, 21:09

John Hughes
I am, Robert, I am!

15 February 2023, 21:52

Robert Podkoński
Looks good already.

20 February 2023, 20:19

John Hughes
I've decided to get a new MG and the track set, both of which will cost considerably more than the original kit, but will certainly improve it, I think. I'll only use the trailer tracks on this one, but I've got another UE kit that can have new tracks.

21 February 2023, 19:26

Rui S
Looking good 👍. Difficult kit ? I've some Mirage kits on stach, but I know they will give me a lot of work so,still waiting;)

21 February 2023, 23:37

John Hughes
Hi Rui. I wouldn't call it a difficult kit. You just have to make allowances for the fact that it is a very cheap kit (8.41 euros) and some corners have been cut in production. For instance, the MG is pretty awful - no pretense at having a trigger or any holes in the cooling jacket, etc. The steel coloured hoop on the front of the carrier is supposed to be a coil of wire, or a towing cable. The shovel won't fit where the instructions say to place it. Another thing that I found was that the taper put on the edges of parts to facilitate removal from the mould is often a bit excessive. Parts that should have a rectangular cross section are more trapezoidal than they might be. Where the track sections join, each section has the top or bottom half of the last link moulded on the end of the run. This gives a good contact point on the next set of links, but it's a pain when trying to fit the tracks around the drive sprocket or idler. You just can't get any angle on that kind of joint.

22 February 2023, 07:59

Rui S
Yap, low price with high quality is difficult to find 🙂 we just have to consider the challenges involved. I always think, bring a cheap kit to a good result his more rewording 😉
keep up the good work 👍

22 February 2023, 12:05

John Hughes
Thanks, Rui. Yes, it is good when you get a good final result from a not so good kit. I'm a bit stuck now as I'm waiting for the tracks & MG to arrive.

22 February 2023, 16:34

Bruce Huxtable
Despite the problems, the tracks look really well done. I bet you are glad they are done already! I didn't have your skills when I made mine... I do recall that the illustrations in the instructions were clearly hand drawn!

23 February 2023, 22:35

Robert Podkoński
I admire your perseverance and skills, John. Fantastic work!

13 March 2023, 20:54

John Hughes
Thanks, Robert.

13 March 2023, 20:58

Project info

Mirage Transporter Renault UE

43 imágenes

1:35

Terminado

1:35 Transporter Renault UE (Mirage Hobby 35514)

Todos los álbumes

Ver todos los álbumes »