AMT 1/24 1968 Shelby GT500
Body prior to primer.
This AMT mold is a cleaning nightmare. Thick mold lines, panel inaccuracies, big gaps in the vents...
A long session of sanding and filling to get to the priming point.
This AMT mold is a cleaning nightmare. Thick mold lines, panel inaccuracies, big gaps in the vents...
A long session of sanding and filling to get to the priming point.
Body primed, ready to paint
Basecoat done. Color is House of Kolor Strato Blue. This is a solvent base acrylic automotive paint. Metallic flakes turned out a little bit out of scale but I think it will be allright.
3 thin layers, one medium layer and one wet layer
3 thin layers, one medium layer and one wet layer
This kit is a mojo killer. I'm setting it aside for a while before I throw it out the window. I'll get back to it in the future.
Komentarzy
9 6 March 2021, 23:57
Dennis Nicolette
Nice work! What's the trick to getting such clean, sharp borders on your strips? I am always fighting paint bleeding under masking tape.
Nice work! What's the trick to getting such clean, sharp borders on your strips? I am always fighting paint bleeding under masking tape.
8 March 2021, 22:20
Patrick Sedney
Thanks Dennis.
I use a glass panel from a picture frame as a cutting matt for the masking tape. Cutting on such a hard surface make the edge perfectly sharp. Then, I put the tape on the surface and rub the edge with the side of a toothpick as much as possible.
When painting, first apply thin coats instead of thicker ones. After a couple of light coats, it should be safe to load a little bit more
Thanks Dennis.
I use a glass panel from a picture frame as a cutting matt for the masking tape. Cutting on such a hard surface make the edge perfectly sharp. Then, I put the tape on the surface and rub the edge with the side of a toothpick as much as possible.
When painting, first apply thin coats instead of thicker ones. After a couple of light coats, it should be safe to load a little bit more
9 March 2021, 01:05
Grant Lehman
Looking good.. I have this kit also... Will get at it eventually...
Looking good.. I have this kit also... Will get at it eventually...
10 March 2021, 19:24
Patrick Sedney
Thank you mate.
Just be patient. The kit's a nightmare. Sanding and filling at its best 🙂
Thank you mate.
Just be patient. The kit's a nightmare. Sanding and filling at its best 🙂
14 March 2021, 20:57