Toyota Supra A80

I decided to make new ones. 

Body in surfacer 

I forgot to take photos of a few steps. It looks quite decent, except for those runs. Hopefully, I'll be able to sand it nicely when it cures. 

The runs. 

I don't like how it looks, so I designed and printed pulleys. 

The alternator looks really good.  

Because brakes didn't fit because of new wheels, I had to design new ones. They are designed so that rotors can rotate, or because they are fragile, then they can be glued together. 

A little too much for my taste. I'll make a new set of wheels with more positive ET. 

Much better 

Printed on a resin printer 

Looks good so far. 

I think I can do better than this. 

A few measurements of the original part, a few photos and this is it. I think this is better, however, it's not the most accurate...We'll see how it will look when it's finished.
cults3d.com/en/3d-mo..yota-supra-by-tamiya 

Unfortunately, when I glued the second diode, glue dropped on the paint... so I have to repaint part of the bumper. :/ 

I'm an idiot cause I clamped cloth to the finished part... 

Repaired! 

Unfortunately, the lens has dimples, so I'm waiting for a replacement part. 

Right now even the license plate is glued in place. The only thing that needs to be done, is those headlights mentioned in previous photos. 

For now, it's finished.