Skoda Fabia S2000 Evo Total Ypres Rally '11 (Job Log)
Panel-line engraved.
Classification by paint color.
The inner surface of the white shell parts was painted black.
L: Gloss White after White Surfacer.
R: Gloss Black for Chrom paint. and painted other color.
R: Gloss Black for Chrom paint. and painted other color.
Masking.
Chrome paint.
The paint applied to the etching peels off easily. So I applied the Vallejo Mecha Primer.
Decal.
The side decals are made in one piece and take about each 2 hours, and a total of over 6 hours.
The side decals are made in one piece and take about each 2 hours, and a total of over 6 hours.
Tail lamp masking...
Clear coat.
Surface levelling.
Polishied with compound (Tamiya Fine)
But, It's a result I'm not happy with.
But, It's a result I'm not happy with.
Finally, I did the polishing again the next day. (done)
Finally, I did the polishing again the next day. (done)
Paint to panel-line and deep mold.
Brush painted Flat, Satin black.
Brush painted Flat, Satin black.
I brushed it with this.
Best recommended~
Best recommended~
Continuing brush painting.
Clear coat to front and rear emblem.
I cut out the silver foil sticker included in the Bandai Pokemon kit and used it.
All done. Ready to assemble.
This is similar to VANTA Black. (Acrylic)
I started assembling it according to the manual.
The wheels were so loose that they had to be fixed with glue.
It was the most complex structure of the steer wheels I've ever made.
The sheet decal on the floor was attached less closely to give a sense of volume.
I plan to detail up only the shoulder side of the seat belt.
I plan to detail up only the shoulder side of the seat belt.
assembling interior.
Inner side of door.
Easy detail-up spare tyre.
A spare tire must be attached before the roll cage is fully assembled.
Then just attach the roof side roll bar. But overall, it is not easy to assemble.
Easy detail-up for shoulder harness.
After putting on the sheet to the proper length...
Wrap it around the roll bar at the back and attach it.
I used Hasegawa sheet for sub tail lamp
But it was invisible from the outside.
It was a waste of time.
It was a waste of time.
I attached the front and rear lamp covers and other trivial parts...
It was not easy to combine the shell with the lower plate.
The wing and the trivial parts on the roof were attached.
For the bonnet hook, etching was included in the kit, but the detail was simple, so I used an etching sold separately.
Finally, by assembling the extension lamp...
Finish
Finish
Finish
Komentarzy
5 October 2024, 06:04 -
Album info
Part-1/2 : motorart.tistory.com/460
Part-2/2 : motorart.tistory.com/463