BMW i8 (Job Log 1/2)

Door is the condition when I receive the kit 

Door is the condition when I receive the kit 

I attached it with tape and left it in the food dryer for about a month. 

Washing 

Removing silver plated parts. 

But, the primer could not be removed. 

Since the marked part is convex, it had to be scrape. 

I thought they were separated because of the mold plan, but the actual vehicle was originally separated as well. 

There was a place where there was no panel line, so I scratched it anew. 

Attached handle for spraying. 

Marked spots must be scrape flat. because I will use metal decal emblem. 

Same on the rear. 

Gloss white surface (momochrom)  

Condition of the painted surface.
It was very nice paint. 

Base color is silver to block the light. 

Mistake. brightness is different. 

Interior is cream color. 

masking. 

German gray 

Masking... 

Masking... 

Masking... 

Masking... 

Masking... 

Masking... 

Masking...
It was little hard. 

Masking... 

Masking... 

Painting 1st color. 

Masking again. 

Painting 2nd color. 

Masking again. (Used GSI masking sol) 

Masking again. (Used Hasegawa masking sol) 

Painting 3rd color. 

Remove it 

It's a bit messy, but if you clean it up, you'll be fine. 

Remove all masked tape. 

Now it's time to raise the clear coat, so the marked area needs to be masked. 

And, I will attach my signature decal to a slightly empty place. 

General position. 

Position is good. But It seems a bit small. 

OK I like this.