MetalEarth ECTO-1 Ghostbusters Wagon

OK - Taking a break from the De Lorean - reorganise my desk accordingly - MetalEarth tools at the ready 

Close up showing the new subject - instructions on the desk - parts list in the reading holder - Metal sheets at left.....GO! 

Oh dear - this is going to involve A LOT of very small parts 

and more - all the "stuff" that goes on the roof rack , I guess 

Here's a trio... 

and another trio 

and here's the whole bunch 

Some close ups of making ONE of these parts - rolled the part around a 3.2mm rod - used small cable ties to help hold that pose & allow for the pin inside to be secured, by way of a "pick" down the barrel! - finished off the job by seating the part with the rod inside in the "Small Shop" Rolling Set plate. Voila! 

Building the roof rack 

Roof rack populated - very busy 

Rear bumper very tricky, requiring more work than one of the bends could cope with - it separated.
Time for some CA 

Two light bars for the roof 

created a rough template for the bumper bend - worked well 

Making the wheels - thanks to 'The Small Shop' for the perfect dowel size!! 

All the wheels done, and attached to "axles" 

Not the prettiest of "faces" - This was very hard to assemble!! 

First idea of the size of this model?!?!?! 

a little montage of the tail-light & fin build - just under an hour to wrangle this together!!!
(and there's still another one to do................)