Aero L-39 ZA Albatros Eduard Week-End

1
February 6, 2016
All the stuff ..... Eduard Week-end kit, Pavla vacu canopy, Pavla VS-1 seats, HDL decals and Xtratech PE set.
2
February 6, 2016
Sprues
3
February 6, 2016
Sprues
4
February 6, 2016
Clear parts & decals from the kit
5
February 6, 2016
WIP , first steps
6
February 6, 2016
First 'stop' .... Pavla seats are far too wide for the kit bathtub. It's not possible to trim them enoug to fit inside ... So I'll use the kit seats , which are also too wide, but no so much that can't be trimmed to fit.
7
March 19, 2016
Cockpit decals from the kit. Very good and accurate, but not por a C but for ZA. Not really a problem as the kit has enough parts to make a ZA.Decals reacted very well to Micro-Sol. Interior Tamiya XF53
8
March 19, 2016
Bang seat head-rests are quite basic. Cushion will be added from plasticard.
9
March 19, 2016
Here it is .. Also added some bits of sprue and plasticard to represent throttle levers and some knobs.
10
March 19, 2016
Cockpit side cushion panels in Tamiya XF22
11
March 19, 2016
Finished instrument panels. Dials were painted with Humbrol Clear Fix and I must say I'm very happy with the result. Ejection handles have been made from red electric wire. Some weathering went on.... Seats Tamiya XF53 and Gunze H421
12
February 5, 2017
Cockpit ready.
13
February 5, 2017
A couple of styrene strips were added to get a more positive fix for the front anti-glare panel. Rear panel seam filled with white glue.
14
February 5, 2017
Front anti-glare panel and reinforcing styrene strips.
15
February 5, 2017
Full cockpit, front panels, and compressor intake ready to be glued to the fuselage halves.
16
March 19, 2016
Just a bit of putty to cover a couple of sink marks
17
March 19, 2016
Some putty was needed at the rear end ... at both sides .... but it's no big deal ....
18
February 5, 2017
Wing halves glued together
19
February 5, 2017
Green stuff putty for the big gaps and Vallejo putty for the smaller ones.
20
February 5, 2017
Fuselage halves glued and some green stuff putty has been put and sanded.
21
February 5, 2017
Some more putty added .... this time Vallejo acrylic.
22
February 5, 2017
More Vallejo putty
23
April 13, 2020
I choose an Egypt machine.... Uppersides base colour is Tamiya XF-60
24
April 13, 2020
Brown colour is a mix of : 20 parts XF2 Tamiya + 12 parts H27 Gunze + 3 parts Gunze H325
25
April 13, 2020
Olive colour is Tamiya XF62
26
April 13, 2020
Air intakes fit was not very good ..... repaired with PVA glue
27
April 13, 2020
I cheated a bit ..... rocket pod should been UB 16 , not UB 32 ,,, but that's what I had (from an old Hasegawa Flogger)
28
April 13, 2020
Moving on
29
April 13, 2020
Undersides Gunze H325
30
April 13, 2020
Canopies masked with Gunze Mr. Mask
31
April 13, 2020
Instead of Furture I tryed Gauzy from AK Interactive .... very good stuff ..... thinner than Future but as glossy as Future
32
April 13, 2020
Finished
33
April 13, 2020
34
April 13, 2020
35
April 13, 2020

Yorumlar

13 1 February 2016, 10:28

Stefan Schneider
I'm in! Nice work so far. Which scheme are you going to realize?

5 February 2017, 15:27

Julian Herrero aka Yuri
Thanks Stefan .... I still have to make up my mind among the Czechoslovakian version (tan and olive green) and Egyptian (tan, brown and green) ,,,, I guess I'll choose the Egyptian.

5 February 2017, 15:48

Łukasz Gliński
Following

5 February 2017, 17:27

Ekki
Following too

6 February 2017, 20:48

Julian Herrero aka Yuri
Hi mates ,,, I'm about to paint the undersides and I have a doubt on the colour. As far as I know should be FS 36375. Eduard matches it to Gunze 325 , but FSM, IPMS Stockholm and Klaus matches it to 308. I've got 308 in my stash and looks rather good. But I haven't 325 for checking ...Any one can help me ?

27 January 2018, 18:21

Christian Lehmann
👍

27 January 2018, 20:25

Christian Lehmann
I also started to build this kit but stoped because I am unsure how to deal with the missing wheel wells

27 January 2018, 20:28

Cuajete
Good start, Julian. Following.

27 January 2018, 20:34

Julian Herrero aka Yuri
Christinan ... in all pictures I've found , all undercarriage doors are closed when the aircraft is on the ground.

28 January 2018, 15:21

Łukasz Gliński
I can confirm the wheel bays on L-39s are closed when undercarriage is fully extended.
@Julian: Wish I could help, but I only used Gunze 308 as FS36375 on my Polish F-16C 🙁
Btw.: Who's Klaus?

28 January 2018, 17:58

Christian Lehmann
Thanks Julkan and Lukasz. The cofusion arrised because of the CMK set which include a wheel well and doors for the main landing gear but none for the front wheel.

28 January 2018, 20:27

Julian Herrero aka Yuri
Thanks Christian & Łukasz . Łukasz ... David Klaus wrote a very comprehensive book on colours for modelling. This very one :
SCM Book: IPMS Color Cross-Reference Guide (IPMS Color Cross-Reference Guide)

29 January 2018, 18:49

David Andrs
Julian: The match via Ultimate Model Paint Guide says: H308 is FS36375, H325 is FS36440. Hope that helps.

29 January 2018, 23:23

Łukasz Gliński
Thx Julian for the info, but I see this book seems quite old😉

30 January 2018, 07:13

Julian Herrero aka Yuri
Łukasz , the book is old , but still a very good and useful reference for colour information

31 January 2018, 19:14

Julian Herrero aka Yuri
Thanks folks ... I'll go for H308 which happens to be in my stash 😉

31 January 2018, 19:15

Julian Herrero aka Yuri
Finished last year ,,, but it's now that I've got the time to post the pictures .....

13 April 2020, 16:34

Łukasz Gliński
Better later than... still, a really nice Albatros 👍

13 April 2020, 17:36

Julian Herrero aka Yuri
Tks Lukasz

13 April 2020, 18:07

Cuajete
Nice painting scheme, Julian. Enhorabuena!😉

16 April 2020, 17:13

Ekki
Nice work.

27 January 2022, 20:38

Robin (WhiteGlint)
Very nice Albatros. Camo scheme looks great! 👍

27 January 2022, 20:47

Julian Herrero aka Yuri
Thanks .... I tryed to find something not so common

28 January 2022, 07:08

Bernd Grün
Nice build and painting. Congrats !!!

28 January 2022, 07:22

Album info

It should've been an easy project with a bit of added detail and aftermarket decals, but not to be finnished in just a Week-end.
I'm not Mike Grant.
😉
But I'd like to ,,,,,
So let's see how it turns out ,,,,
Pavla seats were discarded ... too big for the cockpit.
Interior : Tamiya XF-53 , XF-22
Seats : Tamiya XF-63 , Gunze H421
Undersides : Gunze H325
Uppersides : Gunze H27 , Gunze (20 H1+12 H27 + 3 H325
All brush painted
In the end the project took much more time than I'd expected. Not an easy shake and bake kit .... at least to me.

Aero L-39 ZA Albatros Eduard Week-End OOB

77 Görüntüler

1:72

Tamamlanan

No Tamiya Extra Thin Cement (Tamiya 87038)

Tüm albümler

Tüm albümleri görüntüle »