SE 4050 Vautour IIB Retro-modelling Переглянути: Слайд-шоу Мозаїка Список 1 June 10, 2018
Main parts ,,, full of rivets.
2 June 10, 2018
Small parts , canopy and decals
3 June 10, 2018
Instructions ... the very old way
4 June 10, 2018
Carefully gluing fuselage halves ... step by step ... bottom side
5 June 10, 2018
both ends .. in the backgroud DC-8 wing being finished ,,,
6 June 10, 2018
Top side and spine
7 8 June 18, 2018
Bellies from engine nacelles .... quite a prominent joint must be sanded
9 June 18, 2018
Engine nacelles top ... Much better than expected.... some careful work with files has been done
10 June 18, 2018
Dorsal spine ... rather good
11 June 18, 2018
This is not so good 🙁 ... Careful sanding must be done
12 June 18, 2018
Fuselage belly .... quite good under a coat of silver paint.
13 June 18, 2018
Hummmm ... this ugly gap and awful lot of work
14 15 June 18, 2018
more arrg .. 😉
16 June 18, 2018
Some sanding has been done ,,, but still not a good joint
17 June 18, 2018
Belly sanded .... rather good
18 August 6, 2018
The gap between taiplane piece and tail slot was very big , so I cut the part in two and sanded the inner "bullet"
19 August 6, 2018
Engine nacelles to wing joints were much better than expected.
20 August 6, 2018
Fuselage sanding done
21 August 6, 2018
Underside joint was acceptable to me ....
22 August 6, 2018
... but some sanding was needed on the upper-sides
23 August 6, 2018
on both wings
24 August 7, 2018
Right fuselage primed
25 August 7, 2018
Upper wings ... not that bad ,,, isn't it ?
26 August 7, 2018
Left fuselage primed
27 August 7, 2018
Nose ... much better than expected
28 August 7, 2018
Nose ... I will NOT rescribe panel lines ... remember ... this is retro-modelling ...
29 August 7, 2018
Wings and engine nacelles
30 August 7, 2018
Wings ans tail glued and in place ... waiting for some more paint ...
31 August 7, 2018
AARRGGG !!!! Some glue went to the tail ,,, but I don't really care ...
32 October 20, 2018
Decalling "intructions"
33 October 20, 2018
Decalling "instructions" , sheet 2 . There is quite a difference from the art box, which depicts a two-seat ,,,, by the way 😉
34 October 20, 2018
Decalling started
35 October 20, 2018
Not bad for decals that are almost 40 years old
36 October 20, 2018
All decals used as is ,,, Good quality from Heller.
37 38 October 20, 2018
Gluing undercarriage ... which is rather difficult to align.
39 October 20, 2018
Make-shift jig. Red decal on tail needs some retouch.
40 41 October 20, 2018
Outrigers have been moved down so that they can touch the "ground"
42 43 October 20, 2018
Plenty of rivets
44 45 Коментарі 8 September 2024, 21:35 -
Album info Out of the box easy retro-project. I've been not so extreme on this retro-project ,,, Acrylics instead of enamels ,,,, but : no detailing , no correcting , no putty , and no airbrush. The kit has no cockpit and no wheel wells .... so it should be a fast project. Paints used : Gunze , Tamiya and Vallejo acrylics.
45 зображення
1:100
Завершені
Усі альбоми Переглянути всі альбоми » 
